Service manual

5. Operation 9-2013
To manually start or stop the generator set:
1. Press the START STOP button on the operator panel, which takes you to the Genset
START/STOP screen.
• The screen will display “Genset Stopped" or “Genset Running," as appropriate.
2. Press START to manually start the generator set and connect it to supply power to the
house. The STANDBY OFF lamp will come on and the display will state: “Genset started
manually (Standby Ready Disabled)."
3. Press STOP to manually stop the generator set and disconnect it. The STANDBY OFF
lamp will come on and the display will state: “Genset stopped manually (Standby Ready
Disabled)."
NOTICE
To start the generator set without connecting loads pick Exercise Now on the Exerciser
Clock screen.
FIGURE 19. GENSET START/STOP SCREEN
5.5 Fault, Maintenance and New Event Screens
Various warning and event screens may appear on the operator panel during Normal or
Emergency Operation.
5.5.1 Fault Screen
If a generator set shutdown fault occurs, a FAULT warning appears with the following
information:
• Brief description of the warning or fault
• The two-digit Fault Code Number
• The time of occurrence of the fault
Press the BACK button to reset the fault and return to the home screen.
See the Fault Log section of this manual to review the log of the last 5 faults.
46 A030A239 (Issue 10)