Service manual

5. Operation 9-2013
• determine if utility power is available
• view the last 20 events/faults on the generator set
This feature is useful for homeowners who travel or have a second home and want to be able to
remotely interface with their generator set. This feature can also help to reduce troubleshooting
time and service calls when the service technician has access to the same web page.
Use of the Ethernet is not required if you do not use web access. To set up your generator set
for web access, complete installation instructions.
NOTICE
Ethernet setup must be done at the generator set location. It cannot be done via the web from a
different location. An available Ethernet port and a high-speed Internet are required for
functionality.
To reset the Internet and email interface IP address and password:
1. Press the MENU button on the home screen.
2. Press the up or down arrow button on the menu screen to select Ethernet Setup.
3. Press the ENTER button on the menu screen.
4. Press the NEXT button to select the field to change.
5. To Reset Password - If you have forgotten your password, select the Reset Password
field and press an up or down arrow. The password will be reset to “cummins". Press the
BACK button to go back to the home screen.
6. IP Address - If DHCP is ON (factory setting), the modem/router will assign the generator
set IP Address displayed here. This is the address you enter in your internet browser
address bar. The address assigned to the generator set may change over time. If, for
example, the modem/router is unplugged, it will probably re-assign new addresses to all of
the devices in the home that it serves. If the IP Address you have been using does not
work any longer, copy down the new address and enter it on the browser page.
7. DHCP ON/OFF - DHCP leaves the factory ON. If more advanced features are desired, the
modem/router probably can be configured for DHCP to be OFF. Refer to the Generator
Set Network Setup Guide regarding the permanent generator set IP Address to assign.
8. Manually Enter IP Address—DHCP OFF - If DHCP is OFF, it will be necessary to
manually enter the IP Address, which consists of four three-digit numbers. To enter a
number, select the hundreds, tens or units field in each three digit number field by pressing
the NEXT and PREV buttons. Push the up or down arrow to increase or decrease the
number in the selected field. Numbers in the units fields will increase by one, in the tens
fields by ten and in the hundreds field by one hundred. Refer to the Generator Set
Network Setup Guide to make sure setup is complete.
NOTICE
If utilizing a remote internet access to the generator set, it is recommended that a UPS
battery backup be connected to your router and/or modem.
54 A030A239 (Issue 10)