Service manual

9-2013 8. Optional Internet/Email Interface Setup
2. Establish an Ethernet connection between the computer and generator set via a common
modem.
3. On the computer, Click Start>Run.
4. On the run menu that appears type “cmd " and click OK.
5. Type “ipconfig " on the DOS window that appears.
Question: Why do I need two IP Addresses to access my generator set?
Answer: You can access your generator set from two networks, your in-home or local network,
and from the World Wide Web, thus requiring two addresses.
• Your local IP Address is different from your World Wide Web IP Address.
• From your in-home network you use the generator set's Static IP Address.
• From the World Wide Web you first need to access your modem, which is
accomplished by typing in the Static IP Address of your Internet connection.
Your modem will then automatically forward you to your generator set on the local network.
A030A239 (Issue 10) 83