Installation manual

7. Operation 4-2010
· Perform the maintenance.
Press the BACK button to return to the home screen.
FIGURE 50. TYPICAL MAINTENANCE DUE SCREEN
7.6.3 New Event Screen
A New Event screen appears whenever system status changes, such as when there is an
interruption of utility power. The screen provides a brief description of the event along with the
time and date of the event.
· The message does not time out, unless superseded by a new event.
· Press the BACK button to return to the home screen.
See the Event Log section of this manual to review the log of the last 20 events.
FIGURE 51. TYPICAL NEW EVENT SCREEN
7.7 Genset Status
To check generator set output voltage and frequency and the total numbers of hours run:
1. Press the MENU button on the home screen.
2. Press the up or down arrow button on the menu screen to select Genset Status.
3. Press the ENTER button on the menu screen and note the values displayed on the Genset
Status screen.
4. Press the BACK button to return to the home screen.
60 A029V088 (Issue 2)