Specifications

Accessory Drive - Installation
Rotate the crankshaft until the accessory drive timing
marks on the camshaft gear are at approximately the 1:00
o’clock position.
Install a new gasket on the accessory drive assembly.
Put the accessory drive shaft dowel pin at approximately
the 11:30 o’clock position when facing the shaft from the
pulley end.
Install the accessory drive assembly in the gear housing
accessory drive mounting hole.
Check the alignment of the camshaft gear and the ac-
cessory drive gear timing marks.
NOTE: The accessory drive shaft dowel pin will be at the
12:00 o’clock position after the accessory drive is installed.
Install and tighten the five accessory drive mounting cap-
screws.
Torque Value: 61 N•m [45 ft-lb]
Engine Assembly (00-02) Accessory Drive - Installation
N14 Page 0-89