Specifications

Engine Support Bracket, Front -
Installation
Install the engine support bracket and the eight mounting
capscrews.
Tighten the capscrews.
Torque Value: 68 N•m [50 ft-lb]
Vibration Damper - Installation
Install two guide pins into the end of the crankshaft. Install
the pulley and the vibration damper.
NOTE: Make sure the mounting surfaces of the crankshaft
nose, the vibration damper, and the pulley are clean, dry,
and free of burrs.
Caution: Do not use an anti-seize compound, penetrat-
ing oil, or oil containing a friction modifier to lubricate
the capscrews. This will result in incorrect capscrew
torque and possible capscrew failure.
Lubricate the threads of the capscrews and the washer
with a film of SAE 15W-40 oil.
Install four of the six mounting capscrews. Remove the
two guide studs, and install the remaining two capscrews.
Install the washers and the capscrews. Keep the crank-
shaft from rotating, and tighten the capscrews to the
following torque values, in the order shown:
Capscrew
Size
SAE
Grade
No. N•m [ft-lb]
5/8-inch 8 258 [190]
Engine Assembly (00-02) Engine Support Bracket, Front - Installation
N14 Page 0-131