Specifications

Bushings (No. 6 through No. 2) - Installation
An alignment pointer, Part No. 3823635, is used to align
the cam bearing oil holes with the oil holes in the block.
To use, mount the bearing on the driver. Place the align-
ment pointer against the machined side of the block at the
cam follower holes with the end of the rod at the top of the
bearing. Rotate the cam bearing until the seam of the
bearing is at the end of the rod. Press the cam bearing
in as described.
Use bushing driver (1), Part No. 3375861, to install bush-
ings No. 1, No. 2, No. 4, and No. 6.
Use bushing driver (2), Part No. 3376412, to install bush-
ings No. 3 and No. 5.
Install the tool assembly through the camshaft bore until
the driver is in the cavity between the bores where the
bushing is to be installed.
Install the bushing guide into the camshaft bore next to
the bore where the bushing is to be installed.
An alignment pointer, Part No. 3823635, is used to align
the cam bearing oil holes with the oil holes in the block.
To use, mount the bearing on the driver. Place the align-
ment pointer against the machined side of the block at the
cam follower holes with the end of the rod at the top of the
bearing. Rotate the cam bearing until the seam of the
bearing is at the end of the rod. Press the cam bearing
in as described.
Cylinder Block - Assembly (01-05) Cylinder Block
N14Page 1-32