Specifications

The capscrews can be checked using a set of calipers if
service tool, Part No. 3823546, is not available. The max-
imum allowable free length (dimension ‘X’), measured
from the bottom of the flange to the end of the capscrew,
is 185.6 mm [7.130 in].
To check the capscrew free length, place the head of the
capscrew in the appropriate slot with the flange against
the base of the slot.
NOTE: Capscrew length must be checked without the hard-
ened washer.
If the end of the capscrew touches the foot of the gauge,
the capscrew is too long and must be discarded.
The capscrew can be used again if there is clearance
between the end of the capscrew and the bottom base of
the tool.
Cylinder Head - Rebuild (02-02) Cylinder Head
N14Page 2-24