Specifications

Lubricating Oil Transfer Tube - Clean-
ing and Inspection for Reuse (07-02)
Cleaning
Use solvent to clean the lubricating oil transfer tube and
the mounting flanges. Dry with compressed air.
Inspection
Visually inspect the tube and the flanges for cracks, cor-
rosion, or other damage.
NOTE: If cracks or damage are found, the transfer tube must
be replaced.
Lubricating Oil Dipstick and Dipstick
Tube - Cleaning and Inspection for
Reuse (07-03)
Cleaning
Remove all gasket material from the hand hole cover
gasket sealing surface.
Use solvent to clean the dipstick, dipstick tube, and the
hand hole cover. Dry with compressed air.
Inspection
Visually inspect the dipstick tube and the hand hole cover
for cracks or damage.
Visually inspect the dipstick tube angle.
NOTE: If cracks or damage are found or if the dipstick tube
does not angle down into the oil pan, the damaged parts or
the dipstick tube must be replaced.
Lubricating Oil Dipstick - Calibration
(07-04)
While the engine is installed in chassis, install the dipstick
in the dipstick tube housing.
Use clean 15W-40 oil to fill the oil pan to the specified
‘‘LOW’’ oil pan capacity level.
Oil Pan Capacity
Liters U.S. Gallons
30 LOW 8.0
35 HIGH 9.5
Lubricating Oil System Lubricating Oil Transfer Tube - Cleaning and Inspection for Reuse (07-02)
N14 Page 7-9