Specifications

Tighten the mounting capscrews in the sequence shown.
Torque Value: 203 N•m [150 ft-lb]
After the capscrews are torqued, check the housing bore
and the surface alignment again before doweling the
housing.
Use the appropriate size capscrews. Attach a plate, Part
No. ST-1232-1, which is contained in drill ream fixture,
Part No. ST-1232.
NOTE: Do not tighten the capscrews so tightly that the plate
will not move.
Use the locator pin to align the plate with the hole for the
dowel pin. Tighten the capscrews. The taper on the pin
must engage the dowel pin hole.
The locator pin must rotate easily after the capscrews are
tightened.
Measure the dowel pins which are to be installed.
Obtain a reamer (1) that is 0.013 mm to 0.02 mm [0.0005-
inch to 0.001-inch] smaller than the dowel.
Flywheel Housing - Redowel to Cylinder Block (16-04) Mounting Adaptations
N14Page 16-10