Service Manual

ISB, ISBe and QSB (Common Rail [...] Lubricating Oil Cooler
Section 7 - Lubricating Oil System - Group 07 Page 7-9
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Leak Test
Use the lubricating oil cooler pressure test kit, Part
Number 3823876, to pressure-test the element to check
for leaks. If leaks are detected, replace the element.
Air Pressure Test
kPa psi
449 MIN 65
518 MAX 75
Install
NOTE: Be sure to remove the shipping plugs from the oil
cooler element.
NOTE: When installing a new lubricating oil cooler be
sure to use the correct part number. Replace with the
same part number or use the engine serial number and
QuickServe OnLine to ensure the use of the correct part.
Assemble the lubricating oil cooler cover, capscrews,
gaskets, and oil cooler.
If the engine uses a lubricating oil cooler cover in which
the lubricating oil filter is mounted low, use the torque
sequence shown.
NOTE: Snug capscrew numbers six and eight, then
tighten in the sequence shown.
Torque Value: 24 N•m [ 212 in-lb ]
If the engine uses a lubricating oil cooler cover in which
the lubricating oil filter is mounted high, use the torque
sequence shown.
Torque Value: 24 N•m [ 212 in-lb ]