Service Manual

ISB, ISBe and QSB (Common Rail [...] Lubricating Oil Filter Head (Remote Mounted)
Section 7 - Lubricating Oil System - Group 07 Page 7-17
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Install
CAUTION
To prevent the possibility of high filter restriction after
installation and causing filter damage, be sure the
lubricating lines, oil filter head inlet and outlet ports
are orientated correctly to the bracket prior to
installation. Failure to do so can cause the center
filter media to break up and be pumped through the
engine.
Install the filter head assembly to the bracket and tighten
the capscrews.
Torque Value: 18 N•m [ 13 ft-lb ]
CAUTION
When installing the lubricating oil flex hoses, be sure
there is proper clearance between the flex hoses and
the alternator electrical connections.
Install the lubricating oil filter flex hoses to the face seal
connection and tighten the tube nuts finger tight. Be sure
the o-rings are in place and properly located.
Tighten the lubricating oil filter inlet and outlet connection
locking nuts.
Torque Value: 76 N•m [ 56 ft-lb ]
Finishing Steps
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
• Install the lubricating oil filter flex hoses to the face
seal connection and tighten the tube nuts finger tight.
Be sure the o-rings are in place and properly located.
• Tighten the lubricating oil supply and return lines.
Refer to Procedure 007-092
• Install a new lubricating oil filter. Refer to Procedure
007-013
• Connect the battery. Refer to Procedure 013-009
• Operate the engine and check for leaks and proper oil
pressure.
• Shut down the engine and check the lubricating oil
level. Add lubricating oil as necessary.