Service Manual

Lubricating Oil Filter Head Adapter ISB, ISBe and QSB (Common Rail [...]
Page 7-18 Section 7 - Lubricating Oil System - Group 07
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Lubricating Oil Filter Head Adapter
(007-018)
Preparatory Steps
WARNING
To reduce the possibility of personal injury, avoid
direct contact of hot oil with your skin.
WARNING
Some state and federal agencies have determined
that used engine oil can be carcinogenic and cause
reproductive toxicity. Avoid inhalation of vapors,
ingestion, and prolonged contact with used engine
oil. If not reused, dispose of in accordance with local
environmental regulations.
CAUTION
Use caution when disconnecting or removing
lubricating oil lines and replacing filters that oil is not
spilled or drained into the bilge area. Do not drop or
throw filter elements into the bilge area. The oil and
oil filters must be discarded in accordance with local
environmental regulations.
NOTE: The face seal washers can fall when removing the
oil lines. Use care not to damage or lose the washers.
Clean the area around the lubricating oil cooler cover.
Tag for location and remove the lubricating oil lines for the
oil filter. Refer to Procedure 007-092
Remove
Make a mark on the lubricating oil cooler housing filter
head adapter and the lubricating oil cooler housing to
align the filter head adapter during installation.
Remove the lubricating oil filter head adapter by removing
the center hose connection.
Clean and Inspect for Reuse
WARNING
When using solvents, acids, or alkaline materials for
cleaning, follow the manufacturer's recommendations
for use. Wear goggles and protective clothing to
reduce the possibility of personal injury.
WARNING
Some solvents are flammable and toxic. Read the
manufacturer's instructions before using.
Use solvent to clean the parts.
Dry with compressed air.