Service Manual

ISB, ISBe and QSB (Common Rail [...] Lubricating Oil Pan
Section 7 - Lubricating Oil System - Group 07 Page 7-23
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Oil Pan, Formed-in-Place Gasket
Remove the lubricating oil pan.
NOTE: You can damage the lubricating oil pan flange by
using a pry bar or screwdriver to break the formed-in-
place gasket seal. Use a utility knife to cut the seal and
loosen the pan.
Remove the suction tube, if necessary. Refer to
Procedure 007-035 in Section 7.
Clean and Inspect for Reuse
WARNING
When using a steam cleaner, wear safety glasses or a
face shield, as well as protective clothing. Hot steam
can cause serious personal injury.
WARNING
Wear appropriate eye and face protection when using
compressed air. Flying debris and dirt can cause
personal injury.
Scrape all remaining gasket material from the oil pan and
the block.
NOTE: The use of air or power tools, such as a high
speed sander with an abrasive pad, to clean the gasket
material can overheat the oil pan and cause damage to
the sealing flange.
Steam clean the oil pan. Dry the oil pan with compressed
air.