Service Manual

ISB, ISBe and QSB (Common Rail [...] Lubricating Oil Pan
Section 7 - Lubricating Oil System - Group 07 Page 7-25
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Oil Pan, Formed-in-Place Gasket
If installing a formed-in-place gasket pan, apply a 4-mm
[1/8-inch] bead of sealant, Part Number 3164070, to the
oil pan mounting surfaces at the cylinder block to front
gear housing joints and the cylinder block to rear gear
housing joints.
Make sure there is a continuous sealing path.
NOTE: Install three guide pins, Part Number 3164977, to
improve alignment of the oil pan sealing components to
the cylinder block.
NOTE: Install the oil pan housing within 10 minutes of
applying the sealant, or it will not seal correctly. Once
installed, allow the sealant to dry for 30 minutes before
running the engine.
Oil Pan, Suspended
Assemble the gasket onto the oil pan.
Install the support mounting flange to the oil pan and
gasket assembly.
Oil Pan, Suspended (four-cylinder)
Tighten all capscrews in the sequence shown in the
illustration.
Torque Value: 26 N•m [ 230 in-lb ]
Oil Pan, Suspended (six-cylinder)
Tighten all capscrews in the sequence shown in the
illustration.
Torque Value: 26 N•m [ 230 in-lb ]