Service Manual

ISB, ISBe and QSB (Common Rail [...] Lubricating Oil System
Section 7 - Lubricating Oil System - Group 07 Page 7-41
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Increase engine speed to rated speed and hold for 30
seconds.
Record the lubricating oil pressure readings at rated
engine speed.
Oil Pressure at Rated Engine Speed
kPa psi
207 MIN 30
Remove the oil pressure gauge/Compuchek® fitting and
install the previously removed plug. For pipe plugs, Refer
to Procedure Procedure 017-007. For straight thread
plugs, Refer to Procedure Procedure 017-011
Drain
WARNING
Some state and federal agencies have determined
that used engine oil can be carcinogenic and cause
reproductive toxicity. Avoid inhalation of vapors,
ingestion, and prolonged contact with used engine
oil. If not reused, dispose of in accordance with local
environmental regulations.
WARNING
To reduce the possibility of personal injury, avoid
direct contact of hot oil with your skin.
NOTE: For most engines use a container that can hold at
least 20 liters [21 qt] of lubricating oil. Some engines may
be equipped with an increased capacity oil pan requiring a
container that can hold 28 liters [30 qt] of lubricating oil.
Operate the engine until the coolant temperature reaches
60°C [140°F].
Shut off the engine.
Remove the oil drain plug. Drain the oil immediately to be
sure all the oil and suspended contaminants are removed
from the engine.
If performing an oil drain as part of a service maintenance
interval, remove and replace the oil filter. Refer to
Procedure Procedure 007-013