Service Manual

Sea Water Pump Support ISB, ISBe and QSB (Common Rail [...]
Page 8-92 Section 8 - Cooling System - Group 08
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Install
Install the sea water pump mounting bracket support.
Push the mounting bracket support against the front of the
cylinder head and hold in place while the capscrews are
being tightened to maintain belt alignment.
Torque Value: 44 N•m [ 32 ft-lb ]
Install the sea water pump mounting bracket and
mounting capscrews.
Tighten the capscrews.
Torque Value: 44 N•m [ 32 ft-lb ]
Finishing Steps
• Install the sea water pump. Refer to Procedure
008-057
• Install the sea water pump drive belt tensioner. Refer
to Procedure 009-058
• Install the sea water pump drive pulley. Refer to
Procedure 008-127
• Install the sea water pump drive belt. Refer to
Procedure 008-126
• Install the belt guard. Refer to Procedure 008-001
• Install the sea water pump inlet and outlet hoses.
Refer to Procedure 008-104
• Install the zinc plug into the aftercooler. Refer to
Procedure 010-005
• Open the sea water supply valve(s).
Operate the engine and check for leaks.