Service Manual

REPTO ISB, ISBe and QSB (Common Rail [...]
Page 9-14 Section 9 - Drive Units - Group 09
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Clean and Inspect for Reuse
WARNING
When using a steam cleaner, wear safety glasses or a
face shield, as well as protective clothing. Hot steam
can cause serious personal injury.
Use a steam cleaner to clean all areas of the REPTO
assembly.
Inspect the PTO shaft bearings for wear or damage.
Replace the PTO shaft bearings if they are worn or
damaged.
Inspect the PTO shaft for damage and/or wear grooves
from the oil seal.
Inspect the PTO shaft gear for damage.
Replace the PTO shaft bearing if it is worn or damaged.
The PTO shaft housing bearing must be replaced every
time the PTO shaft is removed.
Inspect the REPTO flywheel housing for cracks at the rear
engine mounting surfaces and flywheel bore.
Inspect the REPTO gear cover for cracks.
Replace the complete REPTO housing and/or gear cover
assembly, if cracked or damaged.
Inspect the idler 2 and PTO shaft support housing
assemblies for cracks or damage.
Replace the complete idler assembly 2 if there are cracks
or damage.
Replace the PTO shaft support housing if there are cracks
or damage.