Service Manual

REPTO ISB, ISBe and QSB (Common Rail [...]
Page 9-16 Section 9 - Drive Units - Group 09
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Position the flywheel housing with the transmission mating
face downward.
Leave a path for the bearing to exit.
Support on a flat surface so the load is evenly distributed.
Use a hammer and suitable bearing drift to push out the
bearing.
Do not damage the flywheel housing.
Discard the bearing.
Preparatory Steps
Use assembly lubricant, Part Number 3163087 or
equivalent, to lubricate the new flywheel housing bearing
outer race and rolling elements.
Position the flywheel housing with the engine mating face
downward.
Support on a flat surface so the load is evenly distributed.
Press the new bearing fully into the housing.
Apply the load only to the outer bearing race. Applying
load to the inner bearing race will result in damage.
Make sure the outer bearing race is fully seated in the
housing recess.
Replace the bearing retainer clip in the flywheel housing.
Make sure the clip is fully located in the groove.
Use assembly lubricant, Part Number 3163087 or
equivalent, to lubricate the flywheel housing accessory
mounting adaptor ring.
Position the flywheel housing with the engine mating face
down.
Support on a flat surface so the load is evenly distributed.
Press the new accessory mounting adaptor ring into the
housing.
Make sure the ring is fully seated in the housing recess.