Service Manual

Idler Pulley Sea Water Pump ISB, ISBe and QSB (Common Rail [...]
Page 9-32 Section 9 - Drive Units - Group 09
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Finishing Steps
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
•
Install the refrigerant compressor. Refer to
Procedure 009-051 (Refrigerant Compressor) in
Section 9.
•
Install the drive belt from the refrigerant compressor.
Refer to Procedure 009-052 (Drive Belt, Refrigerant
Compressor) in Section 9.
•
Install the belt guard, if equipped. Refer to
Procedure 008-001 (Belt Guard) in Section 8 of the
ISBe, ISB, and QSB (Common Rail Fuel System)
Service Manual, Bulletin 4021271, or Procedure
008-001 (Belt Guard) in Section 8 of the ISC, ISCe,
QSC8.3, ISL, ISLe3, ISLe4 and QSL9 Engines
Troubleshooting and Repair Manual, Bulletin
4021418.
•
Connect the battery. Refer to Procedure 013-009
(Battery Cables and Connections) in Section 13 of
the ISBe, ISB, and QSB (Common Rail Fuel
System) Service Manual, Bulletin 4021271, or
Procedure 013-009 (Battery Cables and
Connections) in Section 13 of the ISC, ISCe,
QSC8.3, ISL, ISLe3, ISLe4 and QSL9 Engines
Troubleshooting and Repair Manual, Bulletin
4021418.
Idler Pulley Sea Water Pump (009-057)
Preparatory Steps
• Remove the belt guard. Refer to Procedure 008-001
• Remove the sea water pump drive belt. Refer to
Procedure 008-126