Service Manual

ISB, ISBe and QSB (Common Rail [...] Cold Starting Aid
Section 10 - Air Intake System - Group 10 Page 10-35
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Remove the electrical supply terminal.
Remove the nylon isolating spacer from the electrical
supply terminal.
Disconnect the cold starting aid wiring.
Remove the ground strap capscrew from the air intake
manifold and remove the ground strap.
Remove the cylindrical cold starting aid assembly from the
air intake manifold.
Brick Type
Disconnect the cold starting aid wiring.
If the cold starting aid is equipped with a ground wire,
make sure to remove it.
Remove the air intake connection.
Some engines may have EGR. On these engines,
disconnect the EGR pressure differential sensor and EGR
temperature sensor.
• Refer to Procedure 100-002 (Engine Diagrams) in
Section E for sensor locations.
Remove the EGR connection tube V-band clamp from the
air intake connection.
• Refer to Procedure 011-025 (EGR Connection Tubes)
in Section 11.
Remove the cold starting aid.