Service Manual

ISB, ISBe and QSB (Common Rail [...] Cold Starting Aid
Section 10 - Air Intake System - Group 10 Page 10-39
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
NOTE: Some engines have EGR. Connect the EGR
pressure differential sensor and the EGR temperature
sensor. Refer to Procedure 100-002 (Engine Diagrams) In
Section E for sensor location.
Install the EGR connection tube v-band clamp.
• Refer to Procedure 011-025 (EGR Connection Tubes)
in Section 11.
Torque Value: 11 N•m [ 97 in-lb ]
Tighten the four mounting capscrews.
Torque Value: 24 N•m [ 212 in-lb ]
Connect the cold starting aid wiring.
If the cold starting aid is equipped with a ground wire,
make sure to install it.
Integral Type
Install the cold starting aid into the air intake manifold and
tighten the capscrews.
Torque Value: 14 N•m [ 124 in-lb ]
Remove the tape, if applied over the air intake manifold.