Service Manual

ISB, ISBe and QSB (Common Rail [...] Turbocharger
Section 10 - Air Intake System - Group 10 Page 10-51
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
NOTE: On automotive and industrial engines, if the
engine experiences a turbocharger damage or any other
event in which oil or debris is introduced into the charge
air system, the charge air system must be inspected and
cleaned. Refer to Procedure 010-027 in Section 10.
NOTE: On Marine engines, if the engine experiences
turbocharger damage or any other event in which oil or
debris is introduced into the intake air system, the
aftercooler assembly must be inspected and cleaned.
Refer to Procedure 010-005 in Section 10.
Install
Automotive and Industrial
WARNING
This component or assembly weighs greater than 23
kg [50 lb]. To prevent serious personal injury, be sure
to have assistance or use appropriate lifting
equipment to lift this component or assembly.
• Apply a film of high-temperature anti-seize compound
to the turbocharger mounting studs.
CAUTION
The new gasket must match the one that was
removed. Use of the incorrect gasket will result in
turbocharger damage. Never reuse a turbocharger
mounting gasket.
• Use a new gasket and install the turbocharger.
• Install and tighten the four mounting nuts.
NOTE: The torque values given have been established
using anti-seize compound as a lubricant.
Torque Value: 43 N•m [ 32 ft-lb ]