Service Manual

Turbocharger ISB, ISBe and QSB (Common Rail [...]
Page 10-52 Section 10 - Air Intake System - Group 10
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
• Install the turbocharger compressor outlet elbow, V-
band clamp, and a new o-ring seal on the turbocharger
compressor discharge outlet, if applicable.
• Tighten the clamp.
Torque Value: 8 N•m [ 71 in-lb ]
• Rotate the compressor housing to fit the intake pipes,
if necessary.
NOTE: Use the snap ring or loosen the V-band clamp to
make necessary adjustments. Make sure the snap ring is
seated and/or the V-band clamp is tight when finished
with adjustment.
• Install the inlet pipe and air inlet connection and
tighten the clamp.
Torque Value: 8 N•m [ 71 in-lb ]
• Install the exhaust pipe and tighten the clamp.
Torque Value: 8 N•m [ 71 in-lb ]
Marine Applications
WARNING
This component or assembly weighs greater than 23
kg [50 lb]. To prevent serious personal injury, be sure
to have assistance or use appropriate lifting
equipment to lift this component or assembly.
CAUTION
The gasket water ports are larger on the top and
bottom passages. The gasket is also marked
“Turbocharger” on the side facing the turbocharger.
The gasket must be installed with the port size
matching the port size of the exhaust manifold and
turbocharger, and with the “Turbocharger” marking
facing the turbocharger to prevent damage to the
turbocharger from overheating.
• Apply a film of high-temperature anti-seize compound
to the turbocharger mounting studs.
• Use a new gasket and install the turbocharger.
• Install and tighten the four mounting nuts.
NOTE: The torque values given have been established
using anti-seize compound as a lubricant.
Torque Value: 43 N•m [ 32 ft-lb ]