Service Manual

ISB, ISBe and QSB (Common Rail [...] Turbocharger
Section 10 - Air Intake System - Group 10 Page 10-53
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Prime
• Install and tighten the turbocharger oil drain line. Refer
to Procedure 010-045 in Section 10.
• Lubricate the bearings by pouring 60 to 90 cc's [2 to 3
oz] of clean 15W-40 engine oil in the turbocharger oil
supply line fitting.
• Rotate the turbine wheel to allow oil to enter the
bearing housing.
Finishing Steps
Automotive and Industrial
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
• Install the charge-air cooler piping. Refer to Procedure
010-019 in Section 10.
• Install and tighten the turbocharger oil supply line.
Refer to Procedure 010-046 in Section 10.
• Install the turbocharger coolant lines, variable
geometry turbocharger only. Refer to Procedure
010-041 in Section 10.
• Connect the electrical connections to the turbocharger,
variable geometry turbocharger only
• Fill the cooling system, variable geometry turbocharger
only. Refer to Procedure 008-018 in Section 8.
• Connect the vehicle batteries. Reference the
equipment manufacturer service information.
• Operate the engine and check for leaks.