Service Manual

Turbocharger Coolant Hoses ISB, ISBe and QSB (Common Rail [...]
Page 10-54 Section 10 - Air Intake System - Group 10
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Marine Applications
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
• Install the oil supply line. Refer to Procedure 010-046
in Section 10.
• Install the coolant lines. Refer to Procedure 010-041 in
Section 10.
• Install the air crossover to the turbocharger. Refer to
Procedure 010-019 in Section 10.
• Install the air cleaner assembly. Refer to Procedure
010-013 in Section 10.
• Install the outlet connection. Refer to Procedure
011-017 in Section 11.
• Fill the engine with coolant. Refer to Procedure
008-018 in Section 8.
• Open the sea water supply valve(s). Reference the
equipment manufacturer service information.
• Connect the vehicle batteries. Reference the
equipment manufacturer service information.
Operate the engine and check for leaks.
Turbocharger Coolant Hoses (010-041)
Preparatory Steps
WARNING
Do not remove the pressure cap from a hot engine.
Wait until the coolant temperature is below 50°C
[120°F] before removing the pressure cap. Heated
coolant spray or steam can cause personal injury.
WARNING
Coolant is toxic. Keep away from children and pets. If
not reused, dispose of in accordance with local
environmental regulations.
CAUTION
Use caution when draining coolant that coolant is not
spilled or drained into the bilge area. Do not pump the
coolant overboard. If the coolant is not reused, it
must be discarded in accordance with local
environmental regulations.
Drain the coolant. Refer to Procedure 008-018