Service Manual

Turbocharger Wastegate Actuator ISB, ISBe and QSB (Common Rail [...]
Page 10-64 Section 10 - Air Intake System - Group 10
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Fit the end-link over the turbocharger wastegate lever pin.
With the spine of the spacer visible and the turbocharger
wastegate lever pushed toward the rod, lay the actuator
alongside the mounting bracket.
NOTE: Do not fit the two studs into the mounting holes at
this time.
Adjust the length of the actuator assembly by removing
from the turbocharger, rotating the end-link, and refitting
the actuator until the underside of the actuator will just fit
over the bracket mounting studs with less than 0.5-mm
[0.020-in] gap.
The setting is correct when the underside of the actuator
will just fit over the bracket with less than 0.5-mm [0.020-
in] gap.
Fit the actuator mounting studs into the holes in the
bracket.
Refit the end-link onto the crank pin. Install the control rod
retaining clip.
Tighten the mounting nuts to proper torque specification.
Torque Value: 8 N•m [ 71 in-lb ]