Service Manual

ISB, ISBe and QSB (Common Rail [...] Air Intake Connection
Section 10 - Air Intake System - Group 10 Page 10-73
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Finishing Steps
With EGR
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
• Install the EGR mixer. Refer to Procedure 011-021 in
Section 11.
• Install the EGR connection tube. Refer to Procedure
011-025 in Section 11.
• Use the following procedure in the ISB, ISBe2, ISBe3,
ISBe4, QSB4.5, QSB5.9, QSB6.7, ISC, QSC8.3, ISL,
ISLe3, ISLe4, and QSL9 CM850 Electronic Control
System Troubleshooting and Repair Manual, Bulletin
4021416, to install the EGR differential pressure
sensor. Refer to Procedure 019-370 in Section 19.
• Use the following procedure in the ISB, ISBe2, ISBe3,
ISBe4, QSB4.5, QSB5.9, QSB6.7, ISC, QSC8.3, ISL,
ISLe3, ISLe4, and QSL9 CM850 Electronic Control
System Troubleshooting and Repair Manual, Bulletin
4021416, to install the EGR temperature sensor. Refer
to Procedure 019-378 in Section 19.
• Install the air intake connection adapter (if applicable).
Refer to Procedure 010-131 in Section 10.
• Install the charge-air piping. Refer to Procedure
010-019 in Section 10.
• Connect the cold starting aid (if equipped). Refer to
Procedure 010-029 in Section 10.
• Connect the batteries. Refer to the OEM service
manual
• Operate the engine and check for leaks.
Without EGR
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
• Install the air intake connection adapter (if applicable).
Refer to Procedure 010-131 in Section 10.
• Install the charge-air piping. Refer to Procedure
010-019 in Section 10.
• Connect the cold starting aid (if equipped). Refer to
Procedure 010-029 in Section 10.
• Connect the batteries. Refer to the OEM service
manual.
• Operate the engine and check for leaks.