Service Manual

ISB, ISBe and QSB (Common Rail [...] Air Intake Connection Adapter
Section 10 - Air Intake System - Group 10 Page 10-79
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Remove the v-band clamp, seal, and air intake connection
adapter.
Remove the air compressor intake line from the adapter (if
applicable).
Clean and Inspect for Reuse
WARNING
When using solvents, acids, or alkaline materials for
cleaning, follow the manufacturer's recommendations
for use. Wear goggles and protective clothing to
reduce the possibility of personal injury.
WARNING
Wear appropriate eye and face protection when using
compressed air. Flying debris and dirt can cause
personal injury.
Clean the air intake connection adapter with solvent and
dry with compressed air.
Inspect the air intake connection adapter, seal, and
clamps for damage, cuts, cracks, holes, or worn sections.
Replace components if necessary.
Install
Install the air intake connection adapter straight piece and
seal to the air intake connection.
Service Tip: If the EGR mixer was removed, make sure it
is installed before tightening the capscrews.