Service Manual

Exhaust Outlet Connection ISB, ISBe and QSB (Common Rail [...]
Page 11-14 Section 11 - Exhaust System - Group 11
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Install the sealing grommet inside the exhaust elbow until
the grommet is even with the edge of the exhaust elbow.
NOTE: Use soapy water on the outside of the grommet to
aid in installation.
Use clamp rings to install the exhaust elbow.
Leave the clamp ring capscrews finger tight to allow the
elbow pivots to align with the exhaust tube.
The o-ring must remain in place during this process or
damage to the o-ring can occur.
Use a hump hose and hose clamps to connect the
exhaust tube to the exhaust connection.
Align the lower elbow with the exhaust tube.
Tighten the hose clamps.
Torque Value: 6 N•m [ 53 in-lb ]
Tighten the clamp ring capscrews.
Torque Value: 23 N•m [ 204 in-lb ]
NOTE: Use soapy water on the inside diameter of both
connection points of the hump hose to aid in installation.