Service Manual

ISB, ISBe and QSB (Common Rail [...] EGR Connection Tubes
Section 11 - Exhaust System - Group 11 Page 11-27
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Place new gaskets onto the tube.
Position the tube, gasket, and V-band clamp on the cooler
and intake cover marmon flange connections. Check for
proper alignment.
Loosely install the capscrews for the tube support brace.
CAUTION
Do not force the tube to fit the intake cover or EGR
cooler marmon flanges. Force fitting the tube will
result in undesirable stress in the tube and possible
tube failure.
If the tube does not align correctly, loosen the four air
intake connection capscrews and reposition the air intake
connection to allow for proper alignment.
Tighten the V-band clamp.
Torque Value: 11 N•m [ 100 in-lb ]
Tighten the support brace capscrews.
Torque Value: 24 N•m [ 212 in-lb ]
Tighten the air intake connection capscrews, if loosened.
Torque Value: 24 N•m [ 212 in-lb ]
Operate the engine and check for exhaust or boost leaks.