Service Manual

Alternator Bracket ISB, ISBe and QSB (Common Rail [...]
Page 13-16 Section 13 - Electrical Equipment - Group 13
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Inspect the alternator brackets for cracks or damage.
If any cracks are found on the alternator brackets, they
must be replaced.
Install
Spool Mount
NOTE: On some applications, the alternator bracket and
water inlet are combined in the same bracket. Refer to
Procedure 008-082, where applicable.
Install the upper alternator bracket and mounting
capscrews.
Install the lower alternator bracket and mounting
capscrew.
Tighten the upper and lower alternator bracket mounting
capscrew.
Torque Value:
M8 24 N•m [ 18 ft-lb ]
M10 43 N•m [ 32 ft-lb ]
Hinge Mount.
Install the upper alternator bracket and mounting
capscrews.
Install the lower alternator bracket and mounting
capscrew.
Tighten the upper and lower alternator bracket mounting
capscrew.
Torque Value:
M8 24 N•m [ 18 ft-lb ]
M10 43 N•m [ 32 ft-lb ]
Pad Mount
CAUTION
If the alternator bracket has alignment roll pins,
assure the pins are contacting the surface on cylinder
head when the bracket is installed. Failure to do so
will cause misalignment of the alternator pulley.
Install the alternator bracket.
Install and tighten the alternator bracket mounting
capscrew.
Torque Value: 45 N•m [ 33 ft-lb ]