Service Manual

Starting Motor ISB, ISBe and QSB (Common Rail [...]
Page 13-26 Section 13 - Electrical Equipment - Group 13
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Measure
Using an inside micrometer or a vernier caliper, measure
the distance from the starting motor mounting flange to
the forward face of the front side of the flywheel ring gear.
NOTE: Include any spacers previously removed when
completing the measurement.
Starting Motor Spacing
mm in
49.28 MIN 1.94
52.32 MAX 2.06
Add or remove spacers as necessary to achieve the
correct starting motor spacing.
Install
For engines with wet flywheel housings, apply a 1.5 to 2.0
mm [0.06 to 0.09 in] wide bead of sealant, Part Number
3164067, to the flywheel housing starting motor mounting
flange.
NOTE: If a starting motor spacer is required, make sure to
apply sealant to the side of the spacer that contacts the
starting motor.
Install the three capscrews, the starting motor, and
starting motor spacer, if required.
Torque Value: 43 N•m [ 32 ft-lb ]