Manualshelf

Service Manual

ManualsBrandsCummins ManualsOtherPart 2 ISB and OSB (Common Rall Fuel system) Service manual
631632633634635636637638639640
Engine Testing (Chassis Dynamometer) ISB, ISBe and QSB (Common Rail [...]
Page 14-6 Section 14 - Engine Testing - Group 14
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Test
WARNING
Check the coolant level only when the engine is
stopped. Wait until the coolant temperature is below
50°C [120°F] before removing the pressure cap.
Failure to do so can cause personal injury from
heated coolant spray.
The following procedure assumes that the lubricating oil
and fuel systems were correctly primed, the dipstick
calibrated, and the engine filled to the correct levels with
lubricating oil and coolant during installation of the engine
into the chassis. If these systems were not serviced
during installation of the engine.
Use the following procedures for instructions on priming
the lubricating oil and the fuel system and calibrating the
dipstick.
• Use the following procedure in the Service Manual,
ISF2.8 CM2220 F101. Refer to Procedure 014-006 in
Section 14.
• Use the following procedure in the Service Manual,
ISF2.8 CM2220 E and ISF2.8 CM2220 AN Bulletin
4022178. Refer to Procedure 014-006 in Section 14.
• Use the following procedure in the Service Manual,
ISF2.8 CM2220 E and ISF2.8 CM2220 AN Bulletin
4022178. Refer to Procedure 014-006 in Section 14.
• Use the following procedure in the Service Manual,
ISF3.8 CM2220 Bulletin 4021704. Refer to Procedure
014-006 in Section 14.
• Use the following procedure in the Troubleshooting
and Repair Manual, ISB and QSB5.9 Engines, Bulletin
3666193. Refer to Procedure 014-006 in Section 14.
• Use the following procedure in the Troubleshooting
and Repair Manual, B3.9, B4.5, and B5.9 Series
Engines, Bulletin 3666087. Refer to Procedure
014-006 in Section 14.
• Use the following procedure in the Troubleshooting
and Repair Manual, ISC, ISCe, QSC8.3, ISL and
QSL9 Engines, Bulletin 4021418. Refer to Procedure
014-006 in Section 14.
• Use the following procedure in the Troubleshooting
and Repair Manual, C Series, Bulletin 3666003. Refer
to Procedure 014-006 in Section 14.
• Use the following procedure in the Troubleshooting
and Repair Manual, ISB, ISBe 4 and 6 Cylinder,
Bulletin 4021271. Refer to Procedure 014-006 in
Section 14.
• Use the following procedure in the Troubleshooting
and Repair Manual, B Series, Bulletin 3810207. Refer
to Procedure 014-006 in Section 14.
• Use the following procedure in the QSL9 CM2350
L102 Service Manual, Bulletin 4332796. Refer to
Procedure 014-006 in Section 14.
Reference the Operation and Maintenance Manual for
instructions on filling the lubricating oil and the cooling
systems.