Service Manual

ISB, ISBe and QSB (Common Rail [...] Engine Lifting Brackets
Section 16 - Mounting Adaptations - Group 16 Page 16-5
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
WARNING
Four 20 mm, grade 10.9, hex head capscrews must be
used to install the front lifting bracket. If shorter
capscrews or capscrews of a different grade are used,
the engine can fall when lifting the engine. Personal
injury and property damage can result.
For engines equipped with pad mount alternators, install
the capscrews and front bracket.
Tighten the capscrews.
Torque Value: 32 N•m [ 24 ft-lb ]
Install and tighten the rear bracket and capscrews.
NOTE: Some engines use a two bolt rear lifting bracket
and some engines use a four bolt rear lifting bracket.
Torque Value:
M10
Step 1 43 N•m [ 32 ft-lb ]
Torque Value:
M12
Step 1 77 N•m [ 57 ft-lb ]
Finishing Steps
If removed, install the number 5 injector supply line and/or
the number 6 injector supply line vibration isolator. Refer
to Procedure Procedure 006-051
If previously removed install the alternator and alternator
bracket. Refer to Procedure Procedure 013-001 and Refer
to Procedure Procedure 013-003
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
Connect the batteries.