Service Manual

ISB, ISBe and QSB (Common Rail [...] Flexplate
Section 16 - Mounting Adaptations - Group 16 Page 16-17
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Install the flexplate and flexplate mounting capscrews.
Tighten the capscrews.
Torque Value: 44 N•m [ 32 ft-lb ]
If the engine is equipped with a flex-coupling guard plate,
install the flex-coupling guard plate onto the flywheel
housing. Position the wiring harness connector at the 11
o'clock position, as shown in the illustration. Install a
capscrew to hold it in place.
Install the remaining eight capscrews.
Tighten the capscrews.
Torque Value: 36 N•m [ 27 ft-lb ]
Finishing Steps
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
WARNING
This component or assembly weighs greater than 23
kg [50 lb]. To prevent serious personal injury, be sure
to have assistance or use appropriate lifting
equipment to lift this component or assembly.
• Connect the batteries. Refer to Procedure 013-009
(Battery Cables and Connections) in Section 13.
• Install the transmission and related components. Refer
to the OEM service manual.
• Operate engine and check for noise or vibration.