Service Manual

ISB, ISBe and QSB (Common Rail [...] Flywheel
Section 16 - Mounting Adaptations - Group 16 Page 16-21
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Remove
NOTE: Use the barring tool, Part Number 3824591, to
hold the flywheel to prevent rotation.
Remove two capscrews 180 degrees apart.
Install two M12 x 1.25 x 90-mm guide pins.
NOTE: If a clutch is used in the equipment, the threads in
the clutch pressure plate mounting capscrew holes can be
metric or standard. Be sure to use the correct capscrews.
Determine the capscrew thread design and size, and
install two T-handles in the flywheel at points (1 and 2).
Remove the remaining six flywheel mounting capscrews.
WARNING
This component weighs 23 kg [50 lb] or more. To
reduce the possibility of personal injury, use a hoist
or get assistance to lift this component.
Remove the flywheel from the guide pins.
Disassemble
NOTE: Removal of the pilot bearing is only necessary if
damaged or when installing a new or rebuilt clutch.
If equipped, remove the pilot bearing.
Use a mandrel and hammer to remove the pilot bearing.
Use an abrasive pad, Part Number 3823258, or
equivalent, to clean the pilot bore