Service Manual

Flywheel Housing ISB, ISBe and QSB (Common Rail [...]
Page 16-42 Section 16 - Mounting Adaptations - Group 16
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Install
NOTE: Before installing the flywheel housing, make sure
any locating dowel rings are in the same position as when
the flywheel housing was removed.
NOTE: The sealant called for in the following step may
appear different than what was originally used to build the
engine.
Apply a 1.5 to 2.0 mm [0.06 to 0.08 in] wide bead of
sealant, Part Number 3164070, to the back side of the
flywheel housing in the path illustrated.
NOTE: Install the flywheel housing within 10 minutes of
applying the sealant or it will not seal correctly. Once
installed, allow the sealant to dry for 30 minutes before
running the engine.
Install the flywheel housing and capscrews.
Tighten the flywheel housing capscrews in the sequence
shown.
NOTE: Some engines are equipped with one additional
capscrew not shown in the illustration. Tighten this
capscrew last in the sequence.
Torque Value:
M10
Step 1 49 N•m [ 36 ft-lb ]
Torque Value:
M12
Step 1 85 N•m [ 63 ft-lb ]
NOTE: Before installing the flywheel housing, make sure
any locating dowel rings are in the same position as when
the flywheel housing was removed.
If previously equipped, install a new rectangular seal on
the rear seal carrier and apply assembly lube, Part
Number 3163087.