Service Manual

Flywheel Housing ISB, ISBe and QSB (Common Rail [...]
Page 16-44 Section 16 - Mounting Adaptations - Group 16
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Install the rear engine support bracket and mounting
capscrews.
Torque Value: 77 N•m [ 57 ft-lb ]
NOTE: Make sure to install any shims or spacers in the
same location as removed.
Lower the rear of the engine.
Install the rear engine mount fasteners.
Tighten to the OEM specification.
Remove the lifting fixture or hoist from the rear of the
engine.
Finishing Steps
If previously removed, install the crankcase breather tube.
Refer to Procedure Procedure 003-018
For rear gear train engines, install the rear crankshaft
seal. Refer to Procedure Procedure 001-024
Install the flywheel/flexplate assembly. Refer to Procedure
Procedures 016-005 and Refer to Procedure Procedure
016-004
Install the starting motor. Refer to Procedure Procedure
013-020
Install the transmission and related components (if
equipped). Refer to the OEM service manual.
If equipped with a wet flywheel housing, fill the flywheel
housing with oil. Refer to the OEM instructions.
If previously removed, attach any OEM components
(mufflers, shift mechanisms, air filters, etc.) to the flywheel
housing. Refer to the OEM instructions.