Service Manual

ISB, ISBe and QSB (Common Rail [...] Engine Drive Shaft
Section 16 - Mounting Adaptations - Group 16 Page 16-59
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
WARNING
This component or assembly weighs greater than 23
kg [50 lb]. To prevent serious personal injury, be sure
to have assistance or use appropriate lifting
equipment to lift this component or assembly.
NOTE: The longer drive shafts can be very heavy. The
technician should consider whether two technicians are
needed for the procedure.
Back out the capscrews (1) from each end of the drive
shaft (2). Support the shaft while removing the last
capscrew from each end. Set the drive shaft to one side.
Setup
Marine Applications
Alignment Kit, Part Number 2892196
• Check the engine side coupler flange for proper
seating prior to alignment tool installation.
• Check all mating surfaces and magnets for debris
which could interfere with tool seating.
Install the alignment tool marked “ENGINE” to the engine
drive coupling flange with blade parallel to the ground.
Install the alignment tool marked “GEAR” to the
transmission input flange with the blade parallel to the
ground.
Confirm that the tools are firmly attached with no
movement of any kind.
Pull out on the release lever to release the tools for
changing position or removal.
Do not pry the alignment tools off with a pry bar,
screwdriver, or similar tool, because damage can occur.