Service Manual

ISB, ISBe and QSB (Common Rail [...] Engine Drive Shaft
Section 16 - Mounting Adaptations - Group 16 Page 16-63
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Driveshafts over 254 mm [10 in] have a grease fitting in
the cross member of the U joints (1). These should be
lubricated with the specified grease.
Use Mercury™ U-joint and Gimbal Bearing Grease, Part
Number 92-802870A1, or equivalent.
Install the top (1) and bottom (3) drive shaft shields on the
transmission end as shown.
Coat the capscrew threads with Loctite™ 277, or
equivalent.
Tighten the drive shaft shield retaining capscrews and
nuts on the transmission end.
Torque Value:
Socket Head Capscrew (2) 36 N•m [ 27 ft-lb ]
Torque Value:
Capscrew and Nut (4) 23 N•m [ 204 in-lb ]
Install the engine end drive shaft shield (1) in the flywheel
housing cover.
Coat the capscrew threads with Loctite™ 277, or
equivalent.
Tighten the drive shaft shield retaining capscrews (2).
Torque Value: 36 N•m [ 27 ft-lb ]
Finishing Steps
Marine Applications
WARNING
Batteries can emit explosive gases. To reduce the
possibility of personal injury, always ventilate the
compartment before servicing the batteries. To
reduce the possibility of arcing, remove the negative
(-) battery cable first and attach the negative (-)
battery cable last.
• Connect the batteries. Refer to Procedure 013-009 in
Section 13.
• Operate the equipment and check for operation and
loose components.