Service Manual

ISB, ISBe and QSB (Common Rail [...] ECM Cooling Plate, Fuel Cooled
Section 6 - Injectors and Fuel Lines - Group 06 Page 6-11
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com
Remove
Remove the ECM and cooling plate mounting capscrews.
Do not lose any of the heat-resistant grommets.
Remove the ECM and cooling plate from the engine.
Drain any remaining fuel into the fuel can.
NOTE: The ECM cooling plate, ECM, and ECM mounting
bracket are removed and installed as an assembly.
NOTE: The ECM mounting bracket has three mounting
studs at the bottom of the bracket and one capscrew at
the top. Remove the top mounting capscrew last.
Remove the three bottom ECM bracket mounting nuts
and grommets.
Remove the top capscrew and the ECM mounting
bracket, ECM, and fuel cooled ECM cooling plate.
Disassemble
For engines without a lift pump remove the cooling plate
from the back of the ECM.
Remove and discard the gasket.
Remove the fuel lines and lift pump from the ECM cooling
plate. Refer to Procedure Procedure 005-045