User`s guide

57
parameter, as described later. Note that a maximum of 35 QC
Configurator parameters can be configured to be displayed on
the Q UICK C HECK CE Monitor screen.
Faults Selector
The Faults selector controls the faults displayed on the
Q UICK C HECK CE Fault Screen. The Default list configuration is
set to view the faults from Engine #1. In order to view the faults
from a different subsystem, such as a Transmission or Brakes,
tap the Faults selector pull-down list to select that subsystem.
Note that component ID information (i.e., Make, Model, and
Serial No.) will also appear at the bottom of the Q UICK C HECK
CE Equipment screen when selecting a subsystem other than
Engine #1 to read faults (Engine #1 component ID information
always appears near the top of the Q UICK C HECK CE Equipment
screen).
Subsystem Screens
The subsystem screens can be navigated through by use of the
four tabs located near the top of the screen, labeled: Engine,
Trans., Brakes, and Vehicle. Each tab has associated with it a
number of parameters that pertain to that label. For example,
parameters associated with a transmission will be found on the
Trans. screen.