User's Guide
20 21
Switch motor response Controls for a dual
drapery
On the drapery you wish to swap the
open and close direction of, pull down
and release the TAU once. The drapery
open and close directions.
Fig. X
Fig. X
2. Swap Directions for Motor 2
To swap the open and close directions
for motor 2, press and release the
bottom left button.
Fig. X
1. Swap Motors
First, depress a tack or pin into hole
in the back of the remote to press and
release the recessed button twice.
The LEDs on the front of the remote
correct mode.
To swap the motor controls, press and
release the top right button.
In some cases, to maximize functionality, users may want to swap the control
functions for the window side and room side curtains. Swaping this will
change both the remote control and the TAU.
On the drapery you wish to swap the
window side and room side curtain
response buttons, pull down and
release the TAU once. The drapery
response buttons.
Fig. X
Fig. X
Master Reset the Drapery
2. Setup The Drapery for Reset
Move the curtain to a position halfway
between full open and full closed.
Fig. X
3. Reconnect Power
Reconnect power to the unit by
plugging the unit back in or by
reconnecting the battery tube.
Fig. X
In some instances it may become necessary to master reset your drapery.
Performing a master reset will restore the drapery to its factory settings,
erasing saved open and closed positions, groups, and all paired remotes.
3. Perform Master Reset
Pull down on the TAU and hold for 10
seconds or until the drapery jogs.
Next, push up on the TAU for 10
seconds or until the drapery jogs.
Your drapery has now been master
reset.
Fig. X
Fig. X
1. Remove Power
Disconnect power from the unit. For
hardwired units, simply unplug the
device. For battery powered units,
remove the battery tube by twisting it
off of the connection wire.
With power disonnected, pull down
on the TAU and release once.