User's Guide

4 5
Wall Mount DRapery Track Installation
and connecting the motors
1. Install the Brackets
3. Install the Track
5. Attach the Drapery
Fig. X
The number of brackets needed will
depend on the desired length of the
track. Screw a bracket into the wall
every 16 inches, or closer if needed.
Be conscious of wall substrait and
drapery weight. If necessary, to use
toggles or anchors to add strength. Be

where the motor will hang.
Starting in the middle, secure the
track onto each of the brackets using
each camlocks. With the camlock arm
facing towards you, push the track so
the camlock features rest in the groove
on the top of the track.
Turn the camlock arm to the left so the
features inside the top track groove
bite in and hold.
Be sure the drapery pins are securely
inserted into the header and are
properly spaced apart and at the
appropriate height in the header (see
chart__).
For ripplefold, snaps will be used
instead of pins.
Snap or hook the drapery into each
carrier, starting with the master carrier
arm(s) and ending with the end(s) of
the track. Wrap the remaining fabric
around the motor, hiding it from plain
sight.
Fig. X
Fig. X
2. Secure the Camlocks
On the under side of each bracket
place a camlock. Secure the camlock
into place by inserting the set screw
from the under-side of the camlock.
Secure the set screw at the top of the
bracket using the washer and bolt.
Fig. X
4. Insert the Carriers
First, determine the number of
carriers needed.
Loosen the screw on the hardstop
and slide it out of the track. Insert
the number of carriers needed. On a
center draw, do this on each side.
Fig. X
Fig. X
Fig. X