User's Guide

8 9
Start up
1. Connect Power
On battery powered units, unscrew
the the TAU from the fastener and
insert (6) or (8) D Alkaline batteries,

onto the fastener.
Fig. X
Be sure to secure any excess cord, leaving no more than 8 inches
unsecured, to reduce the risk of child strangulation.
Fig. X
Fig. X
Fig. X
On units powered over Ethernet,
run the wire as desired to the power
and commuication port, then plug
the ethernet cable into the control
housing.
On low voltage units, power up by
plugging the unit into the desired
outlet.
2. Set Limits
     
      
curtain moves to the full open and full
closed positions. These positions can
be changed at any time. To change
these positions, see the instructions
on page __.
Fig. X
Change Positions on the drapery Track
(Single)
Change the open Position
2. Set the Open Position
By hand, pull the curtain until it
reaches the desired full open position.
3. Exit Mode
Pull down on the TAU once to exit
learn mode. The drapery will jog to

1. Enter Learn Mode
Pull down and release the TAU so the
drapery moves towards the direction
you would like to set as the “open”
position. After the drapery reaches
the position, it will stop moving.
   
seconds, or until the drapery jogs.
Release the TAU.
Fig. X
Fig. X
Fig. X
Note: If you have a remote control
paired to the device, you can use it to
move the curtain into the desired full
open position. A press and release
will move the curtain half an inch in a
direction while a press and hold will
move the curtain continuously.
Fig. X
Optional Programming steps for the
Drapery Track
On rechargeable battery powered
units, screw the TAU onto the fastener.