Technical information

21
Barrel Adjuster
Pinch nut/bolt
Ferrule
Brake adjustment
Although the brake on your scooter is set at the factory, you may need to adjust it slightly as the brake pad wears over
time.
Find the rear brake on the left side of the scooter, attached to the rear wheel.
The brake barrel adjuster is shown in the photo below. This adjuster simply increases or decreases the tension on the
brake cable, setting the brake pad’s initial position.
To increase braking power:
Turn the barrel adjuster nut counter-clockwise, unscrewing it
about 1/2 turn at a time. Spin the rear wheel after each turn
of the barrel, checking for brake drag, then use the handlebar
brake lever to test stopping power.
As the barrel adjuster nut is unscrewed braking power will
increase, but if it is turned too far brake drag will occur. The
goal of adjusting the brake is to nd a setting where the rear
wheel spins freely, then stops powerfully when the hand brake
is applied.
Use caution when adjusting the brake! If the barrel adjuster
nut is unscrewed too far, it will become detached and the
brake will no longer be effective. If this happens, screw the
barrel back into its hole a few turns.