Owner`s manual

103
DRIVETRAIN
The drivetrain of a bicycle refers to all parts that transmit power to
the rear wheel including the pedals, chain, chainwheel, crank set and
freewheel.
PEDALS
Pedals are available in a variety of shapes, sizes and materials, and
each are designed with a particular purpose in mind. Some pedals
can be fitted with toe clips and straps. These help to keep the feet
correctly positioned and allow the rider to exert pulling force, as well as
downward pressure, on the pedals. Use of toe clips with straps requires
practice to acquire the necessary skill to operate them safely.
Inspection
Pedals should be inspected every month, taking note of the following
areas:
Check correct tightness into the crank arms. If pedals are •
allowed to become loose, they will not only be dangerous but will
also cause irreparable damage to the cranks.
Check that pedal bearings are properly adjusted. Move the •
pedals up and down, and right to left, and also rotate them by
hand. If you detect any looseness or roughness in the pedal
bearings then adjustment, lubrication or replacement is required.
Ensure that the front and rear pedal reflectors are clean and •
securely fitted.
Also ensure that the toe clips, if fitted, are securely tightened to •
the pedals.
L = Left
Turn counter-clockwise
to tighten.
R = Right
Turn clockwise
to tighten.
Never ride with loose pedals.
!