Owner`s manual

Seat and Handlebar Mounting Reflectors

First attach the reflector to the reflector bracket with the reflector screw, see the top

diagram. Next, remove the clamp screw and open the clamping reflector bracket.

Place clamping reflector bracket around the handlebar or seatpost. If the clamp is

too loose, insert a rubber spear inside of the clamp. Tighten the clamp screw to hold

reflector assembly in place, see the second diagram. Finally, adjust the reflector

assembly in place and ensure that it is upright and facing away from the bike.

Seatstay Mount Reflector Bracket Assembly

First insert one washer onto the hex bolt and insert hex bolt through the reflector

bracket and then through the seatstay bridge. Next, insert a second washer onto the

bolt and thread a hex nut onto the bolt behind the seatstay bridge. Tighten bolts until

snug, making sure the reflector is in an upright position. See diagram at the bottom

right.