Owner`s manual

Front Derailleur

Shift both shifters to the smallest number indicated and place the

chain on the corresponding cog and chainwheel. Disconnect the front

derailleur cable from the cable anchor bolt. Check the position of the front

derailleur; it should be parallel with the outer chainwheel and clear the

largest chainwheel by 1-3mm when fully engaged.

With the chain on the smallest chainwheel in front and the largest cog

in back, adjust the Low limit screw so the chain is centered in the front

derailleur cage. Reconnect the cable, pull any slack out, and tighten the

anchor bolt securely. Shift the front shifter to the largest chainwheel.

If the chain does not go onto the largest chainwheel, turn the high limit

screw in 1/4 turn increments counter-clockwise until the chain engages

the largest chainwheel. If the chain falls off the largest chainwheel, and

into the pedals, you will need to turn the High limit screw in 1/4 turn

increments clockwise until the chain no longer falls off.

Shift through every gear, using the barrel adjusters to fine tune the

cable tension. The barrel adjuster for the front derailleur is located on

the front shifter where the cable comes out of the shifter. Clockwise will

loosen the cable tension and direct the chain closer to the frame while

counter-clockwise will tighten the cable tension and direct the chain

away from the frame.

Do not ride a bicycle that is not shifting proper-

ly. Overlooking proper adjustments may cause

irreparable damage to the bicycle and/or bodily

injury. Never move the shifter while pedaling

backward, nor pedal backwards after having

moved the shifter. This could jam the chain and

cause serious damage to the bicycle and/or

rider.

Low Adjusting Screw

Cable Anchor Bolt

Derailleur Cage

High Adjusting

Screw

Chainguide

clearance of

1-3mm